Country Selection

Please select the country where your order will be shipped to.

Samick Masters limbs
Further Information
Samick Masters limbs

Samick Masters limbs

For outstanding performance look no further than the Samick Masters limbs. Constructed from high modulus UD carbon, SS Cross Carbon with a block-type hard Maple wood core developed and fine tuned over many years experience. Available in (25H) 66in, 68in and 70in lengths in draw weights between 34-46lbs.

International Limb Fitting (ILF).

  • Material: High modulus UD carbon, SS cross carbon with a block-type hard Maple wood core
  • Lengths (25H): 66in, 68in, 70in
  • Draw Weights: 34-46lbs in 2lb increments

Bracing Height Recommendations:

  • Short 66in Limbs (with 25H) = 20.5 - 23cm
  • Medium 68in Limbs (with 25H) = 21 - 23.5cm
  • Long 70in Limbs (with 25H) = 21.5 - 24cm

Mix and Match Warning

The basic principle of International fitting limbs and risers is for all items, regardless of manufacturer, to be interchangeable. However, due to the re-design of certain manufacturers products this is no longer the case.

A particular case in point is the current range of Hoyt risers where the pivot point has now been moved back in line with the dovetail location. This pivot point on most other bows is on the leading edge of the pocket. This has resulted in some cases of poor fitting and non-alignment of limbs and in extreme cases even breakage due to the increased strain on the limbs.

All manufacturers will make their limbs and risers to specifically suit their own brand. Whilst most limbs and risers from all manufacturers will fit together, there are subtle differences in tolerances and the way they locate. Some use the end of the limb pocket as the pivot whilst other use the Dovetail location. Some rate their limbs at lowest limb adjustment, some for mid position. These are just two examples.

On this basis you can still "mix and match" limbs and risers from different manufacturers, but we are advising caution.